Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

First, enter the Task Slot Number from the numbers that are listed. Depending on the task you have selected, you will have to enter a number of other information, starting with the new Debug Level that you wish to enable for this task. The Debug Level applies to all units associated with this task.

   Task DNPMST00  Status ( All)

Valid Debug Level:
0 - Fatal Errors    (Ending)
1 - General Errors  (Error)
2 - Status Messages (Status)
3 - Data Display    (Display)
4 - Data Dump       (Dump)

Debug Level 0-4 or 'S'tats ? 4

...

Enter the new Debug Level that you wish to enable set for Field Units on this FieldUnitChannel.  

NOTE: the Debug Level applies to all Field Units of the same protocol under this Master Channel. (To see diagnostics for only some Field Units on a channel, you must disable diagnostics on the other units.)

Valid Debug Level:
0 - Fatal Errors    (Ending)
1 - General Errors  (Error)
2 - Status Messages (Status)
3 - Data Display    (Display)
4 - Data Dump       (Dump)

Debug Level 0-4 ? 4

Enter the FieldUnit Address to which enable at the above diagnostics status will be appliedlevel, or -1 to apply this change to for all FieldUnits on the channel.

Enter 1 to enable the diagnostics for the FieldUnit(s), or 0 to disable diagnostics.

...

Enter the new Debug Level that you wish to enable for the RTDB of on this FieldUnitMaster Channel 

NOTE: the Debug Level applies to all enabled Field Units under this Master Channel. (To see diagnostics for only some Field Units on a channel, you must disable diagnostics on the other units.)

Valid Debug Level:
0 - Fatal Errors    (Ending)
1 - General Errors  (Error)
2 - Status Messages (Status)
3 - Data Display    (Display)
4 - Data Dump       (Dump)

Debug Level 0-4 ? 4

...